High pressure black fuel line / fuel line, can be used to replace fuel line on other models with 6mm ID fuel lines

This high pressure fuel hose is rated to 225 PSI. It has been designed for use with Modern Chemically Aggressive Bio-Ethanol Enriched Petrol Formulations (E5 & E10) As per currently served petrol pump petrol. Confirms to SAE J30 R7 and BS AU 108. See FUA00004 for hose clips

 2 in stock

AP8144069

M5 flanged screw, many applications including rocker cover trim on pre 2014 V7 small twins

See FRA81505 for this screw in a black finish

 2 in stock

AP8152339

Stainless steel braided hose oil lines for heads. Head connectors are not included

Always replace crush washers (SIA12200) when replacing oil lines

 2 in stock

 05153630 GU05153630 05 15 36 30
 0515 3630 0515.3630 05.15.36.30

Head gasket for models with round pushrod tunnels

 2 in stock

 13022001 GU13022001 13 02 20 01
 1302 2001 1302.2001 13.02.20.01

Threaded adaptor connecting oil line to cylinder head

Fits to ENA14660

 2 in stock

 14153660 GU14153660 14 15 36 60
 1415 3660 1415.3660 14.15.36.60

Complete 950cc piston and Nikasil coated barrel kit including gudgeon pin, piston rings and circlips. Piston is low compression. This kit with Italian made piston and rings is an an alternative to Gilardoni kits which can often be in short supply.

Components for one cylinder. See ENA18102 for similar kit made by Gilardoni

 2 in stock

18060102-z 18060102 GU18060102 18 06 01 02
 1806 0102 1806.0102 18.06.01.02

O ring, used for oil filter cover

Change at every oil change

 2 in stock

1A023580

Pair of black tubular rocker cover protector bars for round and square barrel engines, these will protect barrels and rocker cover in the unfortunate event of your bike being dropped

These head protectors bolt to the head using existing rocker cover bolts, they won't fit models with fairing lowers that wrap around the cylinders (e.g. Spada) without modification. To modify simply reduce the length of the rear section of the bar to stop short of the fairing and insert the supplied grommet. These bars are supplied with a plastic grommet for each end, this will need chamfering or leaving off on round head models with bolt on rocker cover breather pipes, e.g. T3. These bars will not fit on a T3 or other model with knee pads

 1 in stock

Pair of chrome tubular rocker cover protector bars for round and square barrel engines, these will protect barrels and rocker cover in the unfortunate event of your bike being dropped

These head protectors bolt to the head using existing rocker cover bolts, they won't fit models with fairing lowers that wrap around the cylinders (e.g. Spada) without modification. To modify simply reduce the length of the rear section of the bar to stop short of the fairing and insert the supplied grommet. These bars are supplied with a plastic grommet for each end, this will need chamfering or leaving off on round head models with bolt on rocker cover breather pipes, e.g. T3. These bars will not fit on a T3 or other model with knee pads

 1 in stock

Pair of tubular chrome rocker cover protector bars for two valve engines with carbs of twin throttle bodies. These will protect barrels and rocker covers in the unfortunate event of your bike being dropped

These head protectors bolt to the head at three points using existing rocker cover bolts

 1 in stock